Sliding Motor

You are here

Sliding Motor

Training Videos


e-Cabinet 24VDC for single motorized vent

Installation video of the electrical cabinet for single motor

  • Overview electrical cabinet manuals
  • Connecting the slide motor
  • Connecting external button
  • Installation of batteries for backup or testing

Diagnose the cabinet power

Download QR-code Training video

e-Cabinet 24VDC for multiple motorized vents

Installation video of the electrical cabinet for multiple motors with Element Controller

  • How to connect cables and external buttons
  • How to install Element Controller
  • Installation of batteries for backup or testing
  • Diagnose the cabinet power

Download QR-code Training video

e-Cabinet LED diagnostics

LED feedback of electrical cabinets

  • Test setup
  • LED options
  • Long term storage or full power off method

Download QR-code Training video 

HFP installation

Hi-Finity Element Inspection
  • Recommended validation before activating motorisation
  • List of attention points

  • Validation of operating forces 


Element Controller Setup

Method 1
  • Press the service button to activate the wireless access
  • Search your device for WIFI access point Reynaers EC-  <serial nr>
  • Password is printed on Element Controller
  • Open web browser and go to 
Method 2
  • Set dip-switches based on table
  • Press and hold the setup button to activate the setup procedure
  • Move vents in correct opening order
  • Confirm configuration with the setup button
  • Press a button on the system when ready to continue the automated setup
    Download QR-code Training video 


KNX Element Controller

Element Controller daughter boards installation - dec2018
  • Safe procedure to install a daughterboard 

Element Controller expert details

Expert training Sliding Motor - dec2018
  • EC expert details

  • Overview of all Element Controller accessible parameters

  • Element Controller settings; buttons and calibration management

  • Individual motor parameters access.

  • General operation and diagnostics 


Element Controller upgrade for KNX

Before using KNX-compatible daughterboard,

upgrade the Element Controller with USB-key:

1. Power OFF
2. Insert USB KEY in Element Controller
3. Press and hold SERVICE button (top button)
4. Power ON
5. Wait until a LED blinks RED below the buttons
6. Release SERVICE button: LED’s start blinking fast
7. Wait until 2 LED blinks slowly at the dipswitch
8. Power OFF
9. Unplug the USB KEY
Ready to use! 

Motor cables

Expert training sliding motor : electrical wiring - dec2018
  • Overview of all possible wires used
  • Overview of most common wirings, connection schemas

CP 155-LS Motorised – Fabrication

Fabrication video of CP 155-LS motorised element
  • Introduction
  • Preparation frame
  • Installation slide-motor
  • Preparation sash
  • Installation lift-motor
  • Cable passage installation

Download QR-code Training video 

CP 155-LS Motorised – Installation

Onsite installation video of CP 155-LS motorised element
  • Installation electric cabinet
  • Sash installation
  • Motor calibration
  • Lift motor test

Download QR-code Training video

Available Documents:


Element controller